29
Using your TV
This secon provides informaon on using the day-to-day features of your TV.
Status light
Your TV has a single status light on the front panel. It goes on and o and blinks in dierent ways depending on the status
of the TV, as shown in the following table:
On (screen is acve) O Screen is communicang that TV is on.
Screensaver (screen is acve) O Screen is communicang that TV is on.
O (no power) O TV is not connected to power.
O (standby) On
TV is connected to power and is ready to
use.
Starng up from o state
Slow pulsing blink unl startup
completes
TV is doing something.
On (receiving update from USB)
Slow pulsing blink unl update
completes
TV is doing something.
Remote control command received Dims on/o once TV has received your command.
Powering down to standby mode
Slow pulsing blink unl the TV
reaches standby.
TV is doing something.
Standby mode energy savings
When you turn o your TV, it may remain in a higher power mode for a few minutes, aer which it goes into a very low
power standby mode. If you turn on the TV again before it has entered the very low power mode, it turns on immediate-
ly. Aer the TV goes into the lower power standby mode, it takes a bit longer to start up.
Watching broadcast TV channels
To watch broadcast TV, select the le in the screen. Your TV remembers the last channel you watched
and starts with that channel playing.
: You also can use the buons on the TV panel to select Antenna TV, as explained in “Standby mode energy
savings” on page 29.
Changing channels
To change channels, you can do any of the following:
To Next Page
Loading...
Need help?
General
