To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...Why is my Honda Outboard Motor overheating?
Your Honda Outboard Motor may be overheating due to several reasons. A clogged cooling water intake port can cause overheating, so cleaning it is recommended. Another potential cause is a shortage of engine oil; adding engine oil to the specified level may resolve the issue. Also, spark plugs with an improper heat range can lead to overheating.
What to do if the overheat warning system comes on in my Honda BF40D Outboard Motor?
If the overheat warning system activates, it could be due to a clogged cooling water intake port. Try cleaning the cooling water intake port. Another potential cause is the use of spark plugs with an improper heat range. In this case, replace the spark plugs.
Why does the oil pressure warning system come on in my Honda BF40D?
The oil pressure warning system might activate due to a shortage of engine oil. Add engine oil to the specified level. It could also be caused by using improper engine oil, so change the engine oil.
What does it mean when the ACG warning system comes on in my Honda BF40D Outboard Motor?
If the ACG warning system is activated, the battery voltage may be too high or too low. Check the battery.
General| Displacement | 808 cc |
|---|---|
| Full Throttle RPM Range | 5, 000-6, 000 RPM |
| Horsepower | 40 HP |
| Cooling System | Water Cooled |
| Starting System | Electric |
| Lubrication | Wet Sump |
| Trim Range | -4° to +16° |
| Tilt Range | 72° |
| Steering | Remote |
| Gear Shift | F-N-R |
| Gear Ratio | 2.08:1 |
| Fuel Tank Capacity | External |
| Fuel Delivery | Programmed Fuel Injection |
| Exhaust | Through Propeller |
| Weight | 205 lbs |
| Shaft Length | L type: 20 in, X type: 25 in |
| Alternator Output | 12V |
| Engine Type | 4-Stroke, SOHC, 3 Cylinder |
| Cylinder Configuration | Inline 3 |
