Honda CLICK160 User Manual

Brakes
Checking the Front Brake Fluid
1. Place your vehicle in an upright position
on a firm, level surface.
2. Check that the brake fluid reservoir is
horizontal and that the fluid level is above
the LWR mark.
If the brake fluid level in either reservoir is
below the LWR mark or both the brake levers
freeplay becomes excessive, inspect the
brake pads for wear.
If the brake pads are not worn, you most
likely have a leak. Have your vehicle
inspected by your dealer.
20220404183646_32K2SD000_eng_BOOK Page 99 Monday, April 04 2022 18:39:28 JST
Maintenance
96
LWR mark
Front brake fluid
reservoir

Honda CLICK160 Specifications

General

Displacement	156.9 cc
Fuel System	PGM-FI (Programmed Fuel Injection)
Transmission	Automatic, V-Matic
Front Suspension	Telescopic Fork
Fuel Capacity	5.5 liters
Ignition	Full Transistorized
Starter	Electric
Seat Height	778 mm
Ground Clearance	138 mm
Engine Type	4-stroke, liquid-cooled
Front Brake	Hydraulic Disc
Rear Brake	Drum
Bore x Stroke	60.0 mm x 55.5 mm
Compression Ratio	12:1
Rear Tire	120/70-14 M/C 61P
Length x Width x Height	1, 929 mm x 1, 088 mm
Front Tire	100/80-14 M/C 48P