Honda CLICK160 User Manual

Engine Oil
Checking the Engine Oil
Check the engine oil with the Idling Stop
switch at (Idling).
1. If the engine is cold, idle the engine for 3
to 5 minutes.
2. Turn the ignition switch to the (Off)
position and wait for 2 to 3 minutes.
3.
Place your vehicle on its centre stand on a
firm, level surface.
4. Remove the oil fill cap/dipstick and wipe it
clean.
5.
Insert the oil fill cap/dipstick until it seats,
but don't screw it in.
6. Check that the oil level is between the
upper level and lower level marks on the
oil fill cap/dipstick.
7. Securely install the oil fill cap/dipstick.
20220404183646_32K2SD000_eng_BOOK Page 95 Monday, April 04 2022 18:39:28 JST
Maintenance
92
Upper level
Lower level
Oil fill cap/dipstick

Honda CLICK160 Specifications

General

Displacement	156.9 cc
Fuel System	PGM-FI (Programmed Fuel Injection)
Transmission	Automatic, V-Matic
Front Suspension	Telescopic Fork
Fuel Capacity	5.5 liters
Ignition	Full Transistorized
Starter	Electric
Seat Height	778 mm
Ground Clearance	138 mm
Engine Type	4-stroke, liquid-cooled
Front Brake	Hydraulic Disc
Rear Brake	Drum
Bore x Stroke	60.0 mm x 55.5 mm
Compression Ratio	12:1
Rear Tire	120/70-14 M/C 61P
Length x Width x Height	1, 929 mm x 1, 088 mm
Front Tire	100/80-14 M/C 48P