25
CONTROLS & FEATURES
i-Monitor
The i-Monitor is a user interface that allows the operator to view (when
the generator is running) total operating time in hours, generator
output, engine RPM, battery voltage, and error messages. The different
display modes are selected by pressing the i-Monitor button.
i-Monitor at Startup
During start up, the i-Monitor display and all three indicators will
simultaneously blink once. The condition of the i-Monitor display and all
three indicators can be checked. Once the generator is running, the
green OUTPUT indicator and the i-Monitor display will remain lit.
Display Backlight Flashes
If the key is left in the ON position for over 30 seconds without starting
the engine, the display will start to flash.
i-Monitor Display
The i-Monitor display is divided into two screens. The single-digit
screen displays the i-Monitor mode, which is represented by a number
1 through 4. The four-digit screen displays the four mode values or any
activated error messages.
i-Monitor Display Mode 1 – Total Operating Hours
This mode displays the total operating hours of the generator. When
the generator is running, the total operating time accumulates. If the
total operating time is less than one hour, the numeric display will be
‘‘0.’’ When the operating time is one hour or greater, the display will be
‘‘1’’ or ‘‘2’’ and so on. Base the generator’s maintenance schedule on
the accumulated time displayed.
SINGLE-DIGIT
SCREEN DISPLAY
i-MONITOR BUTTON
FOUR-DIGIT
SCREEN DISPLAY
36Z376000.book 25 ページ ２０１４年９月１９日 金曜日 午後６時２６分
To Next Page
Loading...
Need help?
General
