89
OPTIONAL PARTS
HANGER KIT
Protect the fuel tank and frame pipe with the protector films during
installation of the hanger.
1.Slide one end of the hanger under the frame pipe on the left side
of
the
generator.
2.Slide the other end of the hanger under the frame pipe
on the right
side of th
e generator.
3.Slide the hanger along the frame pipes to align the center
of the
hang
er with the recessed part on the rear side of the fuel tank.
4.Install the hanger brackets on both
ends of the hanger and tighten
the
8×16 mm flange bolts securely.
TORQUE:
24–29 N·m (2.4–3.0 kgf·m, 17–22 lbf·ft)
PROTECTOR FILM
(commercially available)
HANGER
8×16 mm FLANGE BOLT (4)
HANGER
BRACKET (2)
HANGER
36Z376000.book 89 ページ ２０１４年９月１９日 金曜日 午後６時２６分
To Next Page
Loading...
Need help?
General
