Honda GC160 User Manual

SERVICING YOUR ENGINE
ENGINE OIL CHANGE
Drain the used oil while the engine is warm. Warm oil drains quickly
and completely.
1. Place
a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick and the drain plug.
2.Allow the used oil to drain completely, then reinstall the drain plug,
and tighten
it securely.
Please dispose of used motor oil in
a manner that is compatible with
the environment. We suggest you take used oil
in a sealed container
to your local recycling center or service station for reclamation. Do
not throw
it in the trash, pour it on the ground, or down a drain.
OIL FILLER CAP/DIPSTICK
DRAIN PLUG

Honda GC160 Specifications

General

Engine Type	Air-cooled 4-stroke OHV
Bore x Stroke	68 mm x 45 mm
Compression Ratio	8.5:1
PTO Shaft Rotation	Counterclockwise (from PTO shaft side)
Ignition System	Transistorized magneto ignition
Lubrication System	Forced splash
Net Torque	10.3 Nm (7.6 lbs ft) @ 2, 500 rpm
Fuel Consumption	1.4 L/h at 3, 600 rpm
Starting System	Recoil start
Fuel Tank Capacity	3.1 liters
Oil Capacity	0.58 liters
Dry Weight	15.1 kg
Displacement	160 cm3 (9.8 cu-in)