Network Graphic Annunciator (NGA) Operations Guide P/N 9020-0675:B1 03/21/13 23
Section 5: Passwords
The options accessible through the NGA's Main Menu are password protected. To access the
various option displays, enter a six-digit password. The factory default passwords are listed in
Table 5.1:
5.1 Factory Default Passwords
Factory default is a term that indicates that the passwords are factory preset-set at these values. It is
possible, and highly recommended, to change these passwords to custom settings using the
CAMWorks programming software.
5.2 NGA Display Lock
In the NGA, you have the option to enable the controls on the touch screen.To enable the controls
on the touch screen, you can configure CAMWorks to require the System’s Level 2 Password. If
the Level 2 Password is not available or the password is incorrectly entered, you cannot use any of
the touch screen controls on the NGA.
Figure 5.2.1 illustrates the NGA Display Lock.
Figure 5.2.1 NGA Display Lock
Level 1= 111111
Level 2= 222222
Level 3= 333333
Level 4= 444444
Table 5.1 Default Passwords
NOTE: Since the passwords are configured as a system-wide setting in CAMWorks, each node
will have an identical set of passwords.
NOTE: For additional information to configure the NGA, refer to the CAMWorks Online Help.
To Next Page
Loading...
Need help?
General
