26 Network Graphic Annunciator (NGA) Operations Guide P/N 9020-0675:B1 03/21/13
Section 7: Walk/Drill Screen
The Walk/Drill screen allows activation and deactivation of the system's Audible and Silent Walk
Test functions as well as the system's Fire Drill mode. The following tabs appear on the Walk/Drill
screen:
7.1 Walk/Drill Screen (Region Tab)
The options that appear on the Region tab of the Walk/Drill screen function within a selected
region. For example, all nodes that exist within the selected region will be placed into the Walk Test
or Fire Drill mode.
Figure 7.1.1 illustrates the screen that appears when the user selects the Regn
tab from the Walk/Drill screen.
Figure 7.1.1 Walk/Drill Screen (Region Tab)
7.2 Walk/Drill Screen Options
Table 7.2.1 describes the tabs and buttons that appear on the Walk/Drill screen.
• Region •Drill • Audible •Silent
Walk/Drill Tabs
and Buttons
Description
Regn Use this tab to open the Numeric Entry Keypad screen to allow direct
entry of a region number. (See Note 1).
Drill Use this tab to open the Fire Drill screen.
Audbl Use this tab to open the Audible Walk Test screen.
Silent Use this tab to open the Silent Walk Test screen.
UP / DOWN Use the up and down arrows to scroll through the list of regions.
(See Note 1).
X Press the "X" button in the upper right corner to close this screen.
NOTE 1: You can only change the Region if the NGA is configured for "Global Reporting."
Table 7.2.1 Walk/Drill Tabs and Buttons
NOTE: You can change the region only if the Global Reporting option is enabled in the
"Service" Menu or via CAMWorks. This option is described in
Section 12 of this
document.
To Next Page
Loading...
Need help?
General
