Honeywell LYNX Touch L5200 Series Programming Guide

Screen Display Function & Programming Options
- 9 -
Program Keys
Keys
Keys
Select from the following options:
Edit Add New Delete
If add new is selected the following options can be programmed:
Key Type User
Serial Number Zone
Button Key 1 – Zn 140 Button Key 2 – Zn 141
Button Key 3 – Zn 142 Button Key 4 – Zn 143
Button Key 5 – Zn 144 Button Key 6 – Zn 145
Button Key 7 – Zn 146 Button Key 8 – Zn 147
Key Type
4 Button Key
Key Type
1 Button Key.
2 Button Key
4 Button Key
6 Button Key
8 Button Key
User
User
Master
Duress
Guest
User 3 through User 30 (L5200CN)
User 3 through User 46 (L7000CN)
Note: The Key must be associated with a specific User/User Code in order for it to operate. Refer to the
LYNX Touch User Guide for additional Information regarding User Codes.
Serial Number
0
Serial Number
When “Serial Number” has been selected “Enter Serial Number or Activate” is displayed.
The transmitter serial number and loop number can be enrolled via RF transmission OR
manually.
Enroll via RF Learning To enroll the device using RF Learning mode three transmissions
(open/close) of the device will be required. The initial transmission activates the RF
Learning mode. A second transmission enrolls the serial number and the system beeps two
times and displays “Activate Sensor Again To Confirm”. A third transmission will confirm the
serial number. The system beeps two times and returns to the Zone programming Screen.
Enroll Manually
Enter the 7-digit serial number printed on the transmitter using the displayed keypad and
select “Done”. The system beeps one time and returns to the Zone programming Screen
Zone
140
Zone
Manually enter a specific two-digit Zone Number (140-155 L5200 OR 140-163 L7000).
Button Key * - Zone *
Button Key * Zn *
Enter a function for each button key from the following options:
Disarm Arm Away
Arm Stay No Response
24 Hour Silent 24 Hour Audible
24 Hour Auxiliary Silent Burglary
Fire No Verification
* Options are the same for each Button/Zone combination.
Program Reporter
Reporter
Reporter
Note: The Follow Me Phone features are not available on the LYNX Touch L7000CN.
Program the following options:
Primary CS Info Secondary CS Info
Follow Me Phone 1 Follow Me Phone 2
Report Selection Options
Downloader
Primary CS Info
Primary Central Station Information
Phone Type
Communicator Type

Honeywell LYNX Touch L5200 Series Specifications

General

Brand	Honeywell
Model	LYNX Touch L5200 Series
Category	Security System
Language	English