14 PSE Series Instruction Manual — P/N LS10227-000NF-E:B 3/29/2021
Installation Addressable Module Mounting
2.3 Addressable Module Mounting
The PSE has been designed to allow the mounting of an addressable control, relay, or monitor module on the main circuit board inside
the power supply cabinet. This allows power to be fed from a PSE output circuit directly to the module, if needed, without running the
power wires outside the cabinet. Remove mounting screws from the positions indicated below and replace with standoffs (included in
hardware kit). Mount the module over the standoffs and secure with screws.
Compatible modules include the FCM-1(A), FDM-1(A), FMM-1(A), FRM-1(A), FDRM-1, XP6-C(A), XP6-R(A), XP10-M(A),
NC-100, NDM-100, NMM-100, NC-100R, and NMM-1000-R.
*If the SLC device does
not match the one in this
figure, refer to the SLC
manual wiring conver-
sion charts for legacy
and newer versions of
the modules.
Figure 2.4 Mounting a Single Module in the PSE Cabinet
Install stacked standoffs
(0.5” + 1.093” M/F)
–
+
–
+
–
+
T
1
0
J
1
B
A
S
E
A
D
D
R
E
S
S
+
0
B
A
S
E
A
D
D
R
E
S
S
+
1
B
A
S
E
A
D
D
R
E
S
S
+
2
B
A
S
E
A
D
D
R
E
S
S
+
3
B
A
0
1
2
3
4
5
6
7
8
9
1
0
1
1
1
3
1
4
1
5
1
2
0
1
2
3
4
5
6
7
8
9
AC1 AC2
TB4
TB15
T
B
3
T
B
2
T
B
1
O
U
T
6
O
U
T
5
O
U
T
4
O
U
T
3
O
U
T
2
O
U
T
1
O
U
T
6
O
U
T
5
O
U
T
4
O
U
T
3
O
U
T
2
O
U
T
1
install 1.093” M/F
standoffs
Note: For instructions on mounting a multi-module and a ZNAC-PS module, refer
to the ZNAC-PS Install Sheet #LS10228-000GE-E.
The multi-module must be installed upside down when the ZNAC-PS is installed. If
the ZNAC-PS is not installed, the multi-module may be mounted in either direction.
Figure 2.5 Mounting a Multi-Module in the PSE Cabinet
To Next Page
Loading...
Need help?
General
