Honeywell NOTIFIER PSE-10 User Manual

PSE Series Instruction Manual — P/N LS10227-000NF-E:B 3/29/2021 29
Section 4: LED Indicators
The PSE power supply has 3 system LED indicators for Power, Batt/Chgr Fault, and Ground Fault. In addition, each available output cir-
cuit also has 2 status LEDs. Refer to Figure 1.1 on page 10 for LED locations. A description of each PSE LED indication is given below.
Ground Fault LED (yellow)
No Fault LED is OFF
Fault Condition:
ground fault
LED is ON constant
Power LED (green)
No Fault LED is ON constant
Fault Condition:
AC power loss (or brownout)
1 short blink (250ms)
Repeating LED blink pattern (non-diagnostic mode and diagnostic mode)
Battery fault LED (yellow)
No Fault LED is OFF
Fault Condition:
Charging path (FETs) failure
1 short blink (250ms)
Repeating LED blink pattern (non-diagnostic mode and diagnostic mode)
Fault Condition:
Charger voltage too low or
Charger Diode Fault
2 short blinks (250ms)
Repeating LED blink pattern (non-diagnostic mode and diagnostic mode)
Fault Condition:
Battery discharged/overcharged
3 short blinks (250ms)
Repeating LED blink pattern (non-diagnostic mode and diagnostic mode)
Fault Condition:
Battery disconnected/fully
discharged
4 short blinks (250ms)
Repeating LED blink pattern (non-diagnostic mode and diagnostic mode)
250ms
250ms
250ms
250ms
250ms
250ms
250ms
250ms
1000ms
pause
250ms
250ms
250ms
250ms
250ms
250ms
250ms
250ms
1000ms
pause
250ms
250ms
250ms
250ms
250ms
250ms
250ms
250ms
1000ms
pause
250ms
250ms
250ms
250ms
250ms
250ms
250ms
250ms
1000ms
pause
250ms
250ms
250ms
250ms
250ms
250ms
250ms
250ms
1000ms
pause

Honeywell NOTIFIER PSE-10 Specifications

General

Brand	Honeywell
Model	NOTIFIER PSE-10
Category	Extender
Language	English