www.honeywell.com/security
58 | Performance Series IP Cameras User Guide
Network Configuration
TCP/IP
Figure 3-20 TCP/IP Interface
Table 3-10 TCI/IP Configuration
Parameter Function
Host Name Configure to set the current host camera’s name. Maximum 32
characters.
Ethernet Card Select an Ethernet port. The default is wire LAN.
Note If you modify these settings, you will have to reboot your
camera to activate the new setup.
Mode There are two modes: Static and DHCP.
The IP/submask/gateway are Null when you select DHCP mode to
automatically search for the IP.
If you select Static mode, then you need to manually set the
IP/submask/gateway.
If you select DHCP mode, then you can view the
IP/submask/gateway from the DHCP.
If you switch from DHCP mode to Static mode, then you need to
reset the IP parameters.
IP/submask/gateway and DHCP are read-only when the PPPoE
function is correctly working.
MAC Address Displays the MAC address.
IP Version Select the IP version, either IPV4 or IPV6. You can access the IP
address of both of these versions.
To Next Page
Loading...
Need help?
General