www.honeywell.com/security
74 | Performance Series IP Cameras User Guide
Events
Video Motion Detection
Figure 3-33 Motion Detection - Video Detection Configuration Interface
Table 3-19 Video Motion Detection - Video Detection Configurations
Parameter Function
Enable Check to enable motion detection.
Working Period Configure the arm/disarm period. Click Setup to open the setup
menu. See Configuring the Working Period on page 75.
Anti Dither The system memorizes only one event during the anti-dither
period. Choose an anti-dither period from 0s to 100s.
Area Configure the motion detection region, its sensitivity, and area. The
default settings covers the entire area. You must click Save to
enable these settings. See Configuring the Motion Detection Area
on page 76.
Record When Record is enabled, you can trigger motion detection to
activate recording.
Record Delay The system can delay recording for a specified time after the alarm
has ended. Choose a delay period from 10s to 300s.
Send Email When this function is enabled, the system sends an email alert to
you when an alarm occurs.
Snapshot Check to enable the system to backup motion detection snapshot
files. (See Path on page 57 for information about configuring where
snapshots are saved.)
To Next Page
Loading...
Need help?
General