Web Operation | 63
800-18161V1 - A - 07/2014
Using Honeywell DDNS to Configure DDNS
Figure 3-24 Using Honeywell DDNS to Configure DDNS
Table 3-12 DDNS Configurations
Parameter Function
Server Type You can select the DDNS protocol from the drop-down list, and then
enable the DDNS function. Select the Honeywell DDNS server (which is
free) to enable the DDNS function.
Server Address The DDNS server IP address.
Domain Name Your self-defined domain name.
Username The user name you enter to log into the server.
Password The password you enter to log into the server.
Update Period This is the frequency at which the camera regularly sends out the life
signal to the server.
You can set the interval value between the camera and the DDNS server
here.
Table 3-13 Honeywell DDNS Configurations
Parameter Function
Server Type You can select the DDNS protocol from the drop-down list, and
then enable the DDNS function. Select the Honeywell DDNS server
(which is free) to enable the DDNS function.
Server Address This is the DDNS server IP address. Under Honeywell DDNS, the
default server address is www.hennvr-ddns.com.
Mode Select Auto or Manual. The default is Auto. If you select Manual,
then you must enter a domain name.
Domain Name Auto and self-defined domain names are both MAC
address.hennvr-ddns.com. You can define the prefix.
Username The user name you enter to log in the server (Optional).
To Next Page
Loading...
Need help?
General