Honeywell Performance HBD3PR2 User Manual

www.honeywell.com/security
58 | Performance Series IP Camera Software Configuration Guide
Configuring Network Settings
TCP/IP
Figure 5-9 TCP/IP Interface
Table 5-7 TCI/IP Configuration
Parameter Function
Host Name
Configure to set the current host camera’s name. Maximum 32
characters.
Ethernet Card
Select an Ethernet port. The default is wire LAN.
Note If you modify these settings, you will have to reboot your
camera to activate the new setup.
Mode
Select Static or DHCP mode.
The IP Address, Subnet mask, and Default Gateway are greyed out
when you select DHCP mode to automatically search for the IP
address.
If Static mode is selected, you must manually assign the IP
Address, Subnet mask, and Default Gateway.
If DHCP mode is selected, the IP Address, Subnet mask, and
Default Gateway are assigned automatically.
Note IP Address, Subnet mask, Default Gateway
, and DHCP
are read-only when
PPPoE is enabled.
MAC Address Displays the MAC address.

Honeywell Performance HBD3PR2 Specifications

General

Brand	Honeywell
Model	Performance HBD3PR2
Category	Security Camera
Language	English