www.honeywell.com/security
64 | Performance Series IP Camera Software Configuration Guide
Figure 5-14 IP Filter Configuration Interface
Before you can restrict access to the cameras through the IP filter, you must first configure the
Trusted Sites here.
Note Add these addresses before enabling Trusted Sites.
Note If you specify a MAC address limitation here, the computer with the specified
MAC address must be in the same network subnet as the IP camera.
CAUTION
If you setup the IP Filter/Trusted sites options and forget
the IP/MAC address that is allowed to access the camera, you will have to
return the camera to the factory to repair the problem.
To Next Page
Loading...
Need help?
General
