12 www.honeywell.com
PW7K1R1E Wiring and Setup
Jumper Configuration
2.3 Jumper Configuration
TB5-3 NC Relay K1-Normal Closed Contact
TB5-4 NO Relay K2-Normally Open Contact
TB5-5 2-C Relay K2-Common Contact
TB5-6 NC Relay K2-Normally Closed Contact
TB6-1 NO Relay K3-Normally Open Contact
TB6-2 3-C Relay K3 – Common Contact
TB6-3 NC Relay K3 – Normally Closed Contact
TB6-4 NO Relay K4 – Normally Open Contact
TB6-5 4-C Relay K4 – Common Contact
TB6-6 NC Relay K4 - Normally Closed Contact
TB7-1 GND Reader Power Ground
TB7-2 TR- 2-Wire RS-485 TR- (B) See Note 1 below
TB7-3 TR+ 2-Wire RS-485 TR+(A) See Note 1 below
TB7-4 RVO 12 VDC Reader Power Output
Table 2: :Jumper Settings
Jumper Set at Description
J1 N/A Factory Use Only
J2 N/A Factory Use Only
J3 N/A Factory Use Only
J4 N/A Factory Use Only
J5 PoE PW6K1R1E powered from the Ethernet connection
12V PW6K1R1E powered from an external 12VDC power source
connected to TB5-3 (VIN), TB5-4 (GND)
J6 N/A Ethernet connection with PoE support
J7 N/A Factory Use Only
Table 1: PW7K1R1E Terminal Connections
Terminal Acronym Description
To Next Page
Loading...
Need help?
General
