76 ScanPal EDA61K Mobile Computer
Erase All Data (Factory Reset)
1. Swipe up from the bottom of the Home screen to access all apps.
2. Select Settings > System > Reset options.
3. Tap Erase all data (factory reset).
4. Tap Reset Phone.
5. If prompted, type your screen lock security pattern, PIN, or password and tap
next ( ).
6. Tap Erase Everything. A message appears informing you an Full factory reset
is being performed.
Clean the Computer
To keep the computer in good working order, you may need to clean the scanner
window, color camera window, and the touch screen. Clean the windows and the
touch screen as often as needed for the environment in which you are using the
computer. The computer withstands application of the following cleaning agents
when applied to a clean soft cloth and removed immediately with a dry soft cloth:
• Acetic acid, 10% in water
• Ethyl alcohol, 10% in water
• Mild soap solutions
Note: Always leave the battery installed when you clean the computer.
1. Press the Power button to suspend the computer.
2. Dip a clean cloth towel in the cleaning agent and wring out the excess.
3. Wipe off the scanner window, camera lens, and flash area. Do not allow any
abrasive material to touch these surfaces.
4. Wipe dry.
5. Let the computer completely air dry before using again.
Caution: Ensure all components are dry prior to mating the computer
terminals and batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
To Next Page
Loading...
Need help?
General