Honeywell SRX2 User Manual

Removing the Electronics Module from a Headband
IMPORTANT
Do not squeeze the battery latches on the sides of the electronics module
while removing it from the headband. The battery may be inadvertently
released from the electronics module.
Do not remove the electronics module by pulling on the microphone boom
as this may cause damage.
1. Grasp the electronics module with one hand, pressing your thumb and
fingertips into the gap between the electronics module and earpiece hub.
2. With the other hand, hold the headband by the earpiece hub.
3. Pull the electronics module away from the earpiece hub.
SRX2/SRX3 Headset Compatibility
SRX3
Honeywell has tested the SRX3 Wireless Headset with the following devices and Vocol-
lect Voice Software versions. Support and compatibility of the SRX3 headset is not lim-
ited to these products, but the customer assumes risks related to untested
configurations.
Device Vocollect Voice Software
Vocollect Talkman A700x VoiceCatalyst 4.0 and newer
Vocollect Talkman A700 VoiceCatalyst 2.4 and newer
Vocollect Talkman A500 VoiceCatalyst 2.4 and newer
The SRX3 Headset requires Honeywell Accessory Update utility v3.0 or greater.
SRX2
Honeywell has tested the SRX2 Wireless Headset with the following devices and Vocol-
lect Voice Software versions. Support and compatibility of the SRX2 headset is not lim-
ited to these products, but the customer assumes risks related to untested
configurations.
13 SRX3 User Guide - Preliminary

Honeywell SRX2 Specifications

General

Brand	Honeywell
Model	SRX2
Category	Headsets
Language	English