6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.
Manually Pairing an SRX2/SRX3 Headset with an
A500, A700, or A700x Talkman Device
Prerequisites:
l The headset is powered off.
l The Talkman device is not in a charger, and there is no wired headset
connected to it.
l The Talkman device is in sleep mode — not in use running a task or voice
application. Its green LED indicator is flashing. If the LED is solid green,
press the Play/Pause button.
l The Talkman device is Bluetooth ready with Bluetooth connection features
enabled.
1. Turn on the headset.
The LED indicator is solid green. The headset remains in
pairing mode for ten minutes then powers off.
2. Press and hold the Plus (+) and Minus (-) buttons on the Talkman device for
two seconds to manually initiate a search for wireless headsets.
3. Immediately hold the headset and device so they are within six inches of
each other but not touching.
The blue LED indicator on the Talkman device turns on,
may flash a few times, and then remains lit. After 20 to 30
seconds, the headset beeps three ascending tones and its
LED indicator flashes blue. These indicators confirm that a
pairing has completed.
4. Put on the headset. You will hear the headset repeat the serial number of the
Talkman device to which it is paired.
5. Verify that the number matches the serial number on the Talkman device.
If you need to attempt the pairing again, re-enter pairing
mode by press the Plus (+) and Minus (-) buttons on the
Talkman device again.
6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.
Screen-Based Pairing with a Handheld Device
Screen-based pairing is the preferred method for pairing a headset with a handheld wire-
less device or PC. This method allows the user to pick a specific headset from a list of
available headset Bluetooth addresses displayed on a screen, and eliminates the problem
of unwanted cross pairing. Auto and manual pairing processes are not available in
screen-based pairing.
SRX3 User Guide - Preliminary 42
To Next Page
Loading...
Need help?
General
