Honeywell VisionPRO 8000 User Manual

42 33-00066EFS—01
Unsuccessful connection
If you are unsuccessful in connecting the thermostat to the Wi-Fi network, you will
see a Connection Failed screen. Press t button for other tips about this failed
connection. Here are three specific reasons the connection might be unsuccessful.
For all Connection Failed screens, pressing Done will return to the Menu screen.
Invalid Password
The password you entered is invalid. Check
that you have the right password and try again.
No IP Address
The thermostat was unable to obtain an IP
address from the router. Verify the router is
correctly set up to automatically assign IP
addresses. This connection can take several
minutes. If there is still no connection, remove
the thermostat from the wallplate for 10
seconds, then snap it back into place.
M35362
Connection Failed
Invalid Password
M35363
Connection Failed
No IP Address

Honeywell VisionPRO 8000 Specifications

General

Display	Touchscreen
Programmability	7-day programmable
Operating Modes	Heat, Cool, Auto, Off
Fan Modes	Auto, On, Circulate
Energy Star Certified	Yes
Backup Battery	Yes
Filter Change Alert	Yes
Installation	Wall-mounted
Connectivity	Wi-Fi
Power Source	Battery or Hardwired
System Compatibility	Heat pump, Gas, Oil, Electric
Stages	2 heat/2 cool
Display Type	Touchscreen
Temperature Range	40°F to 90°F
Humidity Control	Yes
Compatibility	Compatible with most heating, cooling, and heat pump systems