LOCK
Turn the plastic ring as shown to
lock the too! in place. To remove
tools, reverse the procedure.
For additional length, attach wand
to the hose using the same proce-
dure as for attaching tools
Tools attach to the wand in the
same manner.
D. Adjust switch and
handle position
_[V Plug cleaner into electrical outlet.
Place handle in the upright posi-
tion, and slide ON-OFF switch to
Normal Speed.
To clean attachments
To clean the hose wipe off dirt
with a cloth dampened with a liq-
uid detergent. Rinse with a damp
cloth. Cleaning tools may be
washed in warm water with a de-
tergent. Rinse and let dry before
using.
Maintenance
The following sections are concerned with proper maintenance of the
cleaner. Familiarize yourself with these home maintenance tasks and
keep this owner's manual in a convenient place where you can refer to it
when needed. Proper use and care of your cleaner will assure continued
cleaning effectiveness.
The bag
Your cleaner has a durable outer bag which covers the throw away bag.
A light wiping with a damp cloth will keep this outer bag clean.
When to replace the throw away bag
Check the bag from time to time. It is recommended that you change the
bag when the dirt reaches the dotted line on the throw away bag. If you
let more dirt than this accumulate, your cleaner may not operate effec-
tively. Change bag frequently when using cleaner on new carpet, due to
rapid accumulation of carpet fluff. Also check dirt duct (see section fol-
lowing belt replacement) for fluff accumulation.
12
To Next Page
Loading...
Need help?
General
