,.u
NOZZLE
Adjustment for carpet
pile height
The cleaning of carpet and rugs
takes place at the nozzle. This is
the opening at the bottom of the
cleaner where the agitator is lo-
cated.
It is necessary for the nozzle to be
adjusted properly to the various
carpet pile heights. The adjust-
ment lever on the front of the
cleaner may be set on three differ-
ent self-adjusting ranges.
On very dense pile plush or shag
carpet, some difficulty in pushing
the cleaner may occur. In this
case, position the adjustment le-
ver on PLUSH or SHAG. When
cleaning non-carpeted floors, set
adjustment lever to LOW/MEDI-
UM and use Normal Speed. Be-
cause of the vigorous action of
the agitator, do not allow
cleaner to run in a stationary
position on any floor covering, as
marring may occur.
Disconnect cleaner from electri-
cal outlet before making nozzle
adjustment.
To change the nozzle adjustment
grasp the handle and tilt the
cleaner forward. Move the lever
with your hand until it "clicks" in-
to the desired position.
Air freshener dispenser
Lift drawer in the bag cap of your
cleaner and insert the air freshener
tablet that has been packed with
your cleaner. Push drawer down
into position.
To Next Page
Loading...
Need help?
General
