HotSpring ACE User Manual

Limelight
®
Hot Tubs Operation Page 9
Water Care System
Boosting
Increasing Chlorine level (pg. 6)
Water Care System
Testing Water
Salt test initiated/in progress (pg. 7)
Water Care System
CheckWater/ConrmUseLevel
Update Use Setting (pg. 6)
Water Care System
Ofine-CircPump
ACE
®
is disabled for 8 hours when
Summer Timer is active
Water Care System
Ofine-HighSalt
Non-operational
High salt level detected -
Correct salt level Clean/Inspect Cell
(pg. 7)
Water Care System
Ofine-InspectCell/CheckSalt
Clean/Inspect cell for scale then
test water with salt test strips and
add salt if needed (pg. 7 & 15)
Water Care System
Contact Dealer For Service
Contact Dealer For Service
Limelight Hot Tubs Operation
System Status
• Water Care Icon – The water care icon, located on the lower left side of the
main control panel, will be illuminated once the ACE salt water sanitizing
system is installed. The icon will flash when the ACE system requires attention.
• Status Indication –
The ACE system
provides feedback
via the spa’s main
control panel. Refer
to the System Status
Messages section for
a complete listing of system status messages and their meanings.
Start-Up and Refill Procedures
At this point your spa should have balanced water, new or properly cleaned filters,
and power. The water care icon on your spa’s main control panel should be flashing,
indicating that action is required.
STEP 1 – Add Salt
1. With the jets running, slowly add the directed amount of salt (see SPA MODEL
table on below) to the filter compartment, one cup at a time.
NOTE: Your fill water may require more or less salt than what is recommended here.

HotSpring ACE Specifications

General

Brand	HotSpring
Model	ACE
Category	Water Filtration Systems
Language	English