Page 12 ACE Salt Water Sanitizing System
STEP 3 – Confirm Use Level
1. In the ACE menu, press the MODE▲ button to scroll until USE is
displayed. If Use Level is correct, then use the ON▲ button to scroll
through the Use Level values until the original value is displayed attain. If
chlorine level is too low or too high, adjust Use Level accordingly.
2. Press the OFF▼ button twice to select and confirm the setting. The water care
icon will flash to indicate that the setting has been updated. Allow 24 hours for a
change in Use Level to register in the chlorine reading on a test strip.
3. Press the MODE▲ button to reach EXIT+. Press ON▲ to return to the
main menu.
NOTE: If the Use Level has not changed, you must still change the Use Level
setting on the spa’s control panel and then change it back, in order to re-set the
thirty day timer and stop the water care icon from flashing.
STEP 4 – Superchlorinate/Shock Spa and Plumbing Lines
1. Use a Freshwater 5-Way test strip to measure chlorine levels.
2. Activate spa’s automatic clean cycle using the main control panel.
3. Increase chlorine level to 5 ppm using granular sodium dichlor.
Chlorine Boost
If the spa is being used more often than usual, it may be necessary to add more
chlorine to the water by “boosting” the ACE
®
system. To increase the chlorine level:
1. In the ACE Menu, press the MODE▲ button until bOOST appears Once in the
bOOST screen, press the ON▲ button to enter the bOOST menu.
2. Press the OFF▼ button twice to select and confirm the boost. The water care
icon will flash to indicate that the setting has been updated. The system will
automatically initiate a salt before the boost cycle. Once the test is complete
(up to 20 seconds) the bOOST screen will flash to indicate that the system is
boosting.
3. Press the MODE▲ button to reach EXIT+. Press ON▲ to return to the main
menu.
IMPORTANT: It takes 24 hours to complete the Boost cycle. The chlorine level
must be maintained between 3-5ppm at all times. Manually add sodium dichlor if
necessary for regular use or shocking the spa.
Salt Test
The ACE system automatically tests the water’s salt level. A manual Salt Test is only
required if the water care icon is flashing and the status screen indicates High salt or Low
salt levels. The ACE System is offline/stops generating when High or Low salt is meas-
ured. Freshwater Salt Test Strips should be used to verify the sodium chloride level.
To conduct a manual Salt Test:
Page 12 Limelight
®
Hot Tubs Operation
To Next Page
Loading...
Need help?
General
