Power cord set requirements10
This chapter provides power cord requirements for countries and regions.
The wide-range input feature of the computer permits it to operate from any line voltage
from 100 V ac to 120 V ac, or from 220 V ac to 240 V ac.
The three-conductor power cord set included with the computer meets the requirements
for use in the country or region where the equipment is purchased.
Power cord sets for use in other countries or regions must meet the requirements of the
country and region where the computer is used.
Requirements for all countries
These power cord requirements are applicable to all countries and regions.
● The length of the power cord set must be at least 1.0 m (3.3 ft) and no more than 2.0
m (6.5 ft).
● All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country or region where the power cord set will
be used.
●
The power cord sets must have a minimum current capacity of 10 A and a nominal
voltage rating of 125 V ac or 250 V ac, as required by the power system of each
country or region.
●
The appliance coupler must meet the mechanical conguration of an EN 60 320/IEC
320 Standard Sheet C13 connector for mating with the appliance inlet on the back of
the computer.
Requirements for
specic countries and regions
To determine power cord requirements for specic countries and regions, use this table.
Table 10-1
Power cord requirements for specic countries and regions
Country/region Accredited agency Applicable note number
Argentina IRAM 1
Australia SAA 1
Austria OVE 1
Belgium CEBEC 1
96
To Next Page
Loading...
Need help?
General
