HP 214B User Manual

Model 2148
Performance Tests
SECTION IV
PERFORMANCE TESTS
4-1 INTRODUCTION
4-2 The procedures in this section test the electri-
cal
performance of the pulse generator using the specifi-
cations of Table 1- 2 as performance standards. All tests
can be performed without access to the interior of the
instrument.
4-3 EQUIPMENT REQUIRED
4- 4 Equipment required for the performance tests
is listed in Table 1-1, Recommended Test Equipment. Any
equipment that satisfies the critical specifications given
in the table may be substituted for the recommended
model(s).
4-5 TEST RECORD
4-6 Results of the performance tests may be tabu-
lated on the Test Record at the end of the test procedures.
The Test Record lists all of the tested specifications and
their acceptable limits. Test results recorded at incoming
inspection can be used for comparison in periodic main-
tenance, troubleshooting, and after repairs or adjustments.
4-7
PERFORMANCE TESTS
4- 8 The performance tests given in this section
are suitable for inco ming inspection, troubleshooting, or
preventive maintenance . During any performance test , all
shields
and connecting hardware must be in place. The
tests are designed to verify the published instrument
specifications, perform the tests in the order g iv en and
record the data on the test card and / or in the data sp2ces
prov i ded at the end of each procedure .
4- 9 Each test is arranged so that the specification
is written as it appears in Table 1-2 . Next, a description
of the test and any special instructions or problem areas
are included. Each test that requ ires test equipment has
a setup drawing and a list of the required equipment.
The inital steps of each procedure give control settings
required for that particular test .
4- 1
Scans by Artekmedia => 2009

HP 214B Specifications

General

Brand	HP
Model	214B
Category	Portable Generator
Language	English