MultiBoot
Software Guide 6–3
The list below describes the default sequence in which drive
numbers are assigned. (The actual startup sequence varies by
configuration.)
■ Default sequence for devices that boot as drive A:
1. Optical drive in a Port Replicator MultiBay or in an
external MultiBay that contains a disc that boots as
drive A.
2. Diskette drive in a Port Replicator MultiBay or in an
external MultiBay.
■ Default sequence for devices that boot as drive C:
1. Integrated optical drive or an optical drive in a Port
Replicator MultiBay or in an external MultiBay
that contains a disc that boots as drive C.
2. Hard drive in the notebook hard drive bay.
3. Hard drive in a Port Replicator MultiBay or in an external
MultiBay.
✎
Since no drive letter is associated with the NIC, changing the boot
order of a NIC does not affect drive letters of the other devices.
Enabling Bootable Devices in
Computer Setup
The notebook can only start up from a USB device or the NIC
if that device has been enabled for inclusion in MultiBoot.
To enable a device or location for inclusion in MultiBoot:
1. To open Computer Setup, turn on or restart the notebook.
Press
f10 while the F10 = ROM Based Setup message is
displayed in the lower left of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
333634-001.book Page 3 Friday, July 18, 2003 8:47 AM
To Next Page
Loading...
