To Next Page

To Previous Page

RTC battery

Description Spare part number

RTC battery (includes cable and double-sided adhesive) not spared

Before removing the RTC battery, follow these steps:

1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect the power from the computer by unplugging the power cord from the computer.

3. Disconnect all external devices from the computer.

4. Remove the bottom cover (see Bottom cover on page 29).

5. Remove the battery (see Battery on page 31).

6. Remove the system board (see System board on page 49).

Remove the RTC battery:

1. Position the system board upside down.

2. Disconnect the cable (1) from the system board.

3. Lift the battery to detach it from the adhesive on the system board (2).

Reverse this procedure to install the RTC battery.

Component replacement procedures 53

Other manuals for HP EliteBook 1050 G1

Questions and Answers:

Need help?

Do you have a question about the HP EliteBook 1050 G1 and is the answer not in the manual?

General