HP EliteOne 800 G1 Service Manual

Stand
Description Spare part number
Tilt/swivel stand 732509-001
Height adjustment stand 698226-001
Two stands are available for the computer:
●
Height-adjustable/recline stand
●
Tilt/swivel stand
Height-adjustable/recline stand (optional)
To remove the stand:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 34).
2. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket,
towel, or other soft cloth to protect the bezel and screen surface from scratches or other damage.
WARNING! Before laying the computer down for service, first grasp the sides of the display
and raise the display to the highest position.
Do not lay the computer down with the sliding stand in the low position. The stand may suddenly
release, which could cause injury or damage to equipment.
36 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis

HP EliteOne 800 G1 Specifications

General

Brand	HP
Model	EliteOne 800 G1
Category	Desktop
Language	English