3.
Remove the two Phillips PM2.0×3.8 screws (1) that secure the speakers to the base enclosure.
4.
Remove the speakers (2).
Reverse this procedure to install the speakers.
RTC battery
Description Spare part number
RTC battery (double-sided tape and cable) 672013-001
Before removing the RTC battery, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 31), and then remove the following components:
a.
Solid-state drive connector board cable (see
Solid-state drive on page 33)
b. Card Reader board cable (see
Card Reader board cable on page 35)
c. Top cover (see
Top cover on page 38)
d. Speakers (see
Speakers on page 46)
Component replacement procedures
47
To Next Page
Loading...
Need help?
General
