2.
Remove the hinge covers (2) from the base enclosure.
Reverse this procedure to install the hinge covers.
Display assembly
Description Spare part number
Display assembly, 14.0-in, AntiGlare, high-definition (includes display panel cable, 2 WLAN
antenna transceivers and cables, and webcam/microphone module and cable)
675507-001
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 31).
5.
Remove the solid-state drive connector board cable (see
Solid-state drive on page 33).
6. Remove the Card Reader board cable (see
Card Reader board cable on page 35).
7. Remove the top cover (see
Top cover on page 38).
8. Disconnect the wireless antenna cables from the wireless audio module (see
Wireless
audio module on page 49).
Component replacement procedures
63
To Next Page
Loading...
Need help?
General
