38
Image file cfa0:/msr3000-cmw710-boot-e000603.bin is self-decompressing......
..........Done.
System image is starting...
Line aux0 is available.
Press ENTER to get started.
Press Enter, and the following prompt appears:
<HPE>
You can now configure the router.
NOTE:
To access the CLI when the device boots with empty configuration, press Ctrl+D.
Examining the router after power-on
After the router is powered on, verify that:
• The LEDs on the front panel are operating correctly:
LED Status Description
PWR Steady green The power supply is supplying power correctly.
SYS Slow flashing green The router is operating correctly.
• The configuration terminal displays information properly. For local configuration, the
configuration terminal displays the boot information (see "Displaying boot information").
• If you press Enter a
s prompted after system bootup, the router is ready to configure.
Configuring basic settings for the router
After the router is powered on for the first time, configure the basic settings for the router. For more
information, see HPE MSR Routers Fundamentals Configuration Guide (V7) and HPE MSR Routers
Fundamentals Command Reference (V7).
To Next Page
Loading...
Need help?
General
