47
1. Pull the release latches away from the memory module at both ends so that the memory
module springs up from the slot.
2. Holding the non-conductive edge, remove the memory module.
Keep the removed memory module for future use.
3. Align the polarization notch of a new memory module with the memory module slot on the main
board and insert the memory module into the slot along the slide rails.
4. Carefully and firmly press the memory module at both ends until you hear a click. This indicates
the memory module is seated in the slot.
5. Verify that the release latches have firmly locked the memory module in position.
Figure 63 Removing a memory module
Figure 64 Installing a memory module
Replacing an air filter
1. Use a Phillips screwdriver to completely loosen the captive screws of the air filter.
2. Gently pull the air filter out along the slide rails.
Figure 65 Removing an air filter
To Next Page
Loading...
Need help?
General
