39
Replacement procedure
IMPORTANT:
• The barcode on the router chassis contains product information that must be provided to local
sales agent before you return a faulty router for service.
• Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to
open the chassis, contact Hewlett Packard Enterprise for permission. Otherwise, Hewlett
Packard Enterprise shall not be liable for any consequence.
Replacing a power supply
Power supplies are hot swappable.
The replacement procedure of an AC power supply is the same as a DC power supply. This section
uses an AC power supply as an example.
To replace a power supply:
1. Locate the power supply to be removed and use a Phillips screwdriver to completely loosen the
captive screws on the power supply.
2. Holding the handle of the power supply with one hand and supporting the bottom of the power
supply with the other hand, gently pull the power supply out of the slot along the slide rails.
Put the removed power supply on an antistatic workbench or into an antistatic bag.
Figure 50 Pulling a power supply out of the slot
3. Install a new power supply. For the installation procedure, see "Installing the router."
Install a filler panel if you do not install a new power supply.
To Next Page
Loading...
Need help?
General
