HP HPE FlexFabric 5930 User Manual

15
3. Align the two-hole grounding lug at one end of the cable with the grounding holes of the
grounding point, insert the grounding screws into the holes, and tighten the screws with a
screwdriver, as shown in Figure 10.
Figure 16
Attaching the grounding cable to the primary grounding point on the HPE
FlexFabric 5930-32Q switch
Attaching the slide rails to the rack
The procedures are the same for attaching 1U and 2U slide rails to the rack. This section uses the 1U
slide rails as an example.
To attach the slide rails to the rack:
1. Identify the rack attachment position for the slide rails.
2. Install cage nuts (user-supplied) in the mounting holes in the rack posts.
3. Align the screw holes in one slide rail with the cage nuts in the rack post on one side, and use
screws (user-supplied) to attach the slide rail to the rack, as shown in Figure 17.
4. Rep
eat the preceding steps to attach the other slide rail to the rack post on the other side.
Keep the two slide rails at the same height so the slide rails can attach into the chassis rails.
Figure 17 Installing the 1U slide rails

HP HPE FlexFabric 5930 Specifications

General

Brand	HP
Model	HPE FlexFabric 5930
Category	Switch
Language	English