22
Figure 25 Installing an LSWM1BFANSC/LSWM1BFANSCB fan tray
Removing a fan tray
WARNING!
• Ensure electricity safety and never touch the rotating fans when you hot-swap a fan tray.
• To prevent an unbalanced fan from causing loud noise, do not touch the fans, even if they are not
rotating.
Removing an LSWM1HFANSC or LSWM1HFANSCB fan tray
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Loosen the captive screw of the fan tray with a Philips screwdriver until it is fully disengaged
from the switch chassis.
3. Grasp the handle of the fan tray with one hand and pull the fan tray part way out of the slot.
Support the fan tray bottom with the other hand, and pull the fan tray slowly along the guide rails
out of the slot.
4. Place the removed fan tray in an antistatic bag.
Removing an LSWM1BFANSC or LSWM1BFANSC fan tray
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Grasp the fan tray handle with one hand to pull the fan tray part way out. Support the fan tray
bottom with the other and pull out the fan tray slowly along the guide rails.
3. Place the removed fan tray in an antistatic bag.
To Next Page
Loading...
Need help?
General