2-5
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
Web Configuration
Displaying System Information
You can display a complete summary of identity, IP Address, port, Trunk/LACP,
and VLAN information for the switch.
Field Attributes
System Identity
• System Name – Name assigned to the switch system.
• System Location – Description of the switch location.
• System Contact – Contact information assigned to the switch.
• Number of Ports – Number of built-in ports.
• Hardware Version – Hardware version of the main board.
• Software Version – Version number of the code.
• Serial Number – The serial number of the switch.
Address Information
• Management VLAN – ID of a configured VLAN. By default, all ports
on the switch are members of VLAN 1. However, the management
station can be attached to a port belonging to any VLAN, as long as
that VLAN has been assigned an IP address.
• IP Address – Address of the VLAN to which the management station
is attached. (Note that the management station must always be in the
Management VLAN.)
• Subnet Mask – This mask identifies the host address bits used for
routing to specific subnets. (Default: 255.255.255.0)
• Gateway IP Address – IP address of the gateway router between the
switch and management stations that exist on other network
segments. (Default: 0.0.0.0)
• MAC Address – The physical layer address of the switch.
Port Information
•Port – Indicates the port number.
• Typ e – Indicates the port type (10/100-T, 10/100/1000-T, or M).
• Link Status – Indicates if the link is Up or Down.
To Next Page
Loading...
Need help?
General
