9
OSPF Stub Router Advertisement for OSPF v3
■ Enhancement (PR_0000071946)—OSPF Stub Router Advertisement for OSPF v3 - renamed to better reflect the
feature. For more information, see the “Introduction to OSPFv3” chapter in the IPv6 Configuration Guide for your
switch.
Show OSPF Neighbor Timers
■ Enhancement (PR_0000054055)—This enhancement provides the ability to display OSPF neighbor timer
information. For more information, see the chapter “IP Routing Features” in the Multicast Routing Guide for your
switch.
OSPFv2 Range Metrics
■ Enhancement (PR_0000067641, CR_0000073680)—Adds NSSA range metrics to OSPFv2. See the Multicast and
Routing Guide, “IP Routing” chapter.
SPF Throttling
■ Enhancement (PR_0000072987, CR_0000077793)—SPF scheduling (throttling) allows the switch to delay SPF
calculations when the network is unstable or there is a change in topology. See the IPv6 Configuration Guide,
“OSPFv3 Routing” chapter, or the Multicast and Routing Guide, “IP Routing” chapter.
OSPFv2 Logging Commands and Command Output
■ Enhancement (PR_0000052548)—Adds improved logging, commands, and command output for OSPFv2
troubleshooting. See the “IP Routing Features” chapter in the Multicast and Routing Guide for your switch.
OSPFv3 over 6in4 Tunnels
■ Enhancement (PR_0000072702)—Both VLANS and tunnels can be assigned to areas and may be collectively
referred to as an IP routing interface. For information on configuring tunnels, see the “IPv6 Tunneling Over IPv4 Using
Manually Configured Tunnels” chapter in the IPv6 Configuration Guide.
Routing
Policy Based Routing (PBR)
■ Enhancement (PR_0000072658)—PBR provides the ability to manipulate a packet’s path based on attributes of
the packet. Traffic with the same destination can be routed over different paths, so that different types of traffic, such
as VoIP or traffic with special security requirements, can be better managed. For more information, see the “Classifier-
Based Software Configuration” chapter in the Advanced Traffic Management Guide for your switch.
Concurrent Meshing and Routing
■ Enhancement (PR_0000068493, CR_0000074060) - Meshing and routing now can be configured simultaneously.
A packet can be routed into a mesh, or be switched through a mesh and then routed. Two routers can be connected
by mesh links, which offers additional network topologies between routers and switches. Concurrent meshing and
routing makes it possible to implement meshing throughout a broadcast domain without the need for additional
switches or the use of another Layer 2 technology such as Spanning Tree to connect meshing domains with routing
switches.
Static Summary Route to RIP
■ Enhancement (PR_0000058804)—Allows the redistribution into RIP of static black hole or reject routes. For more
information, see the “IP Routing Features” chapter in the Multicast Routing Guide for your switch.
To Next Page
Loading...
Need help?
General
