23
Version KA.15.10.0007
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0007.
■ Authentication (CR_0000122439) - With multiple certificates installed on the switch, PEAP-MSCHAPv2
authentication fails when using Windows Server 2008 R2 Network Policy Server (NPS).
■ Crash (CR_0000122225) - The switch might reboot unexpectedly when using VRRP with a message similar to
Software exception in ISR at btmDmaApi.c:378.
■ Crash (CR_0000124443) - Rarely, when ports go offline, then back online while voice VLAN requests are being
sent, the switch might reboot unexpectedly with a message similar to
Software exception at sw_sem.c:1036 -- in 'mSnmpCtrl' -> Deadlock found!.
■ IGMP (CR_0000105902) - IGMPv2 LEAVE processing functionality no longer works for a multicast group after
receipt of IGMPv1 group specific membership query (GSMQ) packet when operating in IGMPv2 mode, even when ip
igmp forcedfastleave 1-24 is enabled.
■ SNMP (CR_0000124187) - With stacking enabled, the time-stamps in SNMP traps do not match sysUptime on the
switch.
■ SNMP (CR_0000124375) - A switch configured to send syslog messages to a server also sends incorrect SNMP
traps, causing unknown trap messages in the syslog server.
■ TFTP (CR_0000124276) - The switch experiences a loss of free memory each time the CLI command copy running-
config tftp is issued by a user or by a network management platform. When memory is depleted on the commander,
the switch will respond to CLI commands such as show run with the error message Translator Failed. In that
state, stack configuration changes might cause 3800 stack members to reboot repeatedly with a message similar to
Reboot of Member ID 2, RFS Error reboot.
Version KA.15.10.0008
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0008.
■ Authentication (CR_0000114307) - The switch does not allow users to login when the configured authentication
method is peap-mschapv2.
■ Crash (CR_0000126636) - It is possible for the switch to reboot unexpectedly, under conditions of very high traffic
volumes and high CPU utilization.
Version KA.15.10.0009
Status: Released and fully supported, and posted on the web.
The following problems were resolved in software version KA.15.10.0009.
■ ACLs (CR_0000122535) - When configuring an ipv4 or ipv6 prefix-list, it is not possible to add an entry to permit/
deny 'any'.
■ CLI (CR_0000125980) - After configuring debug ip pbr, the output of show debug does not include pbr in the list of
enabled debug types.
■ CLI (CR_0000127335) - Using the CLI command show tech all can cause the system to reboot unexpectedly.
■ Crash (CR_0000120116) - With OSPF configured, in a rare situation the switch might reboot unexpectedly with a
message similar to
Software exception at rt_table.c:4453 -- in 'eRouteCtrl', task ID = 0xa9c4c00 ->
Routing Stack: Assert Failed.
To Next Page
Loading...
Need help?
General
