EasyManuals Logo
Home>HP>Switch>J9575A

HP J9575A User Manual

HP J9575A
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
22
Version KA.15.10.0005
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0005.
ACLs (CR_0000119956) - Removing an ACL entry (ACE) that is a comment (a "remark") causes undesired changes
to the ACL.
BGP (CR_0000122109) - When configuring a BGP neighbor, the switch does not accept IP addresses that would be
broadcast or network addresses in a classful addressing scheme. For example, the switch does not allow the neighbor
addresses 15.255.255.255 or 15.0.0.0.
CLI (CR_0000115033) - With stacking disabled and SSH file transfer enabled, the switch does not allow the user
to "copy" the crash-data, crash-log, or coredump files via SFTP.
Counters (CR_0000119114) - The output of the show system temperature command gives incorrect values.
Display Issue (CR_0000121028) - Some MAC addresses are displayed incorrectly in the output of CLI commands
show lldp info remote-device and display lldp neighbor-information list.
Routing (CR_0000120907) - A switch that has a default gateway or less-specific route configured does not allow
users to connect to the switch's IP loopback address. The packets are routed instead of being accepted by the switch.
SNMP (CR_0000120223) - The Entity MIB lists the stacking module as available hardware even if no stacking
module is inserted in the switch.
TFTP (CR_0000119184) - The switch experiences a loss of free memory each time command output is copied to
a TFTP server. When memory is no longer available, the TFTP will fail with a message similar to
TFTP download in progress. Failed to allocate a new TFTP client. 00000K Request failed.
Version KA.15.10.0006
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0006.
802.1X (CR_0000122837) - Clients have issues with authentication when 802.1X and MAC Authentication are both
configured on a port.
Crash (CR_0000117378) - When a stack member crashes, that member might reboot continuously instead of
rejoining the stack.
Distributed Trunking (CR_0000120627) - Some traffic is lost when a member of a Distributed Trunk pair is
rebooted.
IPv6 (CR_0000122825) - IPv6 packets with a mask of /65 to /127 are routed to the default route instead of the
intended destination.
PIM-DM (CR_0000122264) - Some PIM-DM multicast streams fail when a default route is configured on the switch.
Spanning Tree (CR_0000110052) - In a topology with multiple MSTP regions and multiple same-cost links
connecting the regions, the CST root port might change to a CST alternate port, and MSTP instances might be blocked
on region boundary ports.
SSH (CR_0000122795) - SSH session disconnects when the SSH key re-exchange takes place.
Switch Hang (CR_0000124001) - In a 3800 stack with CDP passthrough configured, the standby will hang when
the commander goes down.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP J9575A and is the answer not in the manual?

HP J9575A Specifications

General IconGeneral
BrandHP
ModelJ9575A
CategorySwitch
LanguageEnglish

Related product manuals