11
Transceivers
10m and 15m Direct Attach Cables (DACs)
■ Enhancement (PR_0000067349) - Adds support for the J9286B 10m and J9287B 15m Direct Attach Cables (DACs).
Display Transceiver Command
■ Enhancement (PR_0000066341, CR_0000072917)—Adds the ability to view diagnostic monitoring information
for transceivers with Diagnostic Optical Monitoring (DOM) support. See “Troubleshooting” in the Management and
Configuration Guide.
Transceiver Diagnostics
■ Enhancement (PR_0000070797)—Adds the ability to view diagnostic monitoring information for copper
transceivers with Virtual Cable Test (VCT) support. For more information, see the "Troubleshooting" appendix in the
Management and Configuration Guide for your switch.
Trunking
Distributed Trunking Switch-to-Switch
■ Enhancement (PR_0000063613)—Adds support for switch-to-switch Distributed Trunking. See “Port Trunking”
in the Management and Configuration Guide.
LACP Enhancements
■ Enhancement (PR_0000069334)—Includes three LACP enhancements:
1. LACP Key - The lacp key option provides the ability to control dynamic trunk configuration. Ports with the same
key will be aggregated as a single trunk. For more information see the "Port Tunking" chapter in the Management
and Configuration Guide for your switch.
2.LACP Debug Logging and Show Commands - The show lacp, show lacp peer, and show lacp counters commands are
added or modified. For more information see the "Port Tunking" chapter and the "Troubleshooting" appendix in
the Management and Configuration Guide for your switch.
3.Displaying Information about LACP Trunk Load Balancing. The show trunks load-balance interface command
displays the port on which the information will be forwarded out for the specified traffic flow with the specified
source and destination address. For more information see the "Port Tunking" chapter and the "Troubleshooting"
appendix in the Management and Configuration Guide for your switch.
Trunk Load Balancing Using L4 Ports
■ Enhancement (PR_0000058115)—Allows the use of TCP/UDP source and destination port number for trunk load
balancing. For more information, see the chapter “Port Trunking” in the Management and Configuration Guide for
your switch.
VLANs
VLAN Multicast Filter Global Configuration
■ Enhancement (PR_0000053047)—Adds a global configuration option that allows each VLAN to have a multicast
filter. See the “Multimedia Traffic Control with IP Multicast (IGMP)” chapter in the Multicast and Routing Guide for
your switch.
To Next Page
Loading...
Need help?
General
