CLI commands
snmp-server allow
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server allow <ip address>/<mask>
Adds a host to the list of IP address from which access to the SNMP interface is permitted.
no snmp-server allow <ip address>/<mask>
Removes a host from the list of IP address from which access to the SNMP interface is permitted.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of bits in the mask.
snmp-server chassis-id
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server chassis-id <name>
Specifies a name to identify the AP. By default, this is set to the serial number of the AP.
no snmp-server chassis-id
Deletes the system name.
snmp-server contact
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server contact <email>
Specifies contact information.
no snmp-server contact
Deletes contact information.
Parameters
<email> Email address.
snmp-server heartbeat period
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server heartbeat period <seconds>
Sets the interval between sending heartbeat traps.
Parameters
<seconds> Heartbeat interval in seconds.
snmp-server location
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
snmp-server location <name>
Specifies the location where the AP is installed.
no snmp-server location
Deletes location information.
2-20
To Next Page
Loading...
Need help?
General
