CLI commands
access-controller restrict location
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
access-controller restrict location (gateway | mac <mac address>)
Identifies the access controller the AP will communicate with.
Parameters
gateway Use the default gateway as the service controller.
mac Use the specified MAC address as the gateway.
<mac address> MAC address. Specify 6 pairs of hexadecimal numbers separated by
colons, with the values a to f in lowercase. For example: 00:00:00:0a:0f:01
service-sensor
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
service-sensor
Enables the service sensor. The service sensor polls a target device at present intervals. If the
device does not respond, the radio is shut off.
no service-sensor
Disables the service sensor.
service-sensor
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
service-sensor (gateway | address<ip address>)
Sets the target device the service sensor will poll. This can be the default gateway or a specific IP
address.
no service-sensor
Disables the service sensor.
Parameters
gateway The service sensor will poll the default gateway.
address The service sensor will poll another device.
<ip address> IP address of the other device. For example: 192.168.10.10
service-sensor poll
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
service-sensor poll <seconds>
Sets the poll frequency.
Parameters
<seconds> Poll frequency. Range: 1 - 3600 seconds.
2-32
To Next Page
Loading...
Need help?
General
