HP Omnibook XE3 Service Manual

2-6 Removal and Replacement HP Omnibook XE3 (Technology Codes GE and GD)
3. Press outward to release the latches at the sides of the SDRAM module, so the free edge of the
module pops up.
Figure 2-4. Removing an SDRAM Module
4. Pull the module out of the connector.
Reassembly Notes
•
Gently press the SDRAM module into the connector at an angle of about 30°, until it is fully
inserted. Then press down on both sides of the module until the latches snap closed.

HP Omnibook XE3 Specifications

General

Brand	HP
Model	Omnibook XE3
Category	Laptop
Language	English