13. To remove the display panel cable, webcam/microphone module, and webcam/microphone module
cable:
a. Remove the display bezel.
b. Remove the display panel.
c. Release the display panel cable from the retention clips (1) and routing channels that are built
into the bottom edge of the display back cover.
d. Detach the webcam/microphone module cable (2) from the display back cover. The webcam/
microphone module cable is attached to the display back cover with double-sided adhesive.
e. Detach the webcam/microphone module (3) from the display back cover. The webcam/
microphone module is attached to the display back cover with double-sided adhesive.
f. Release the ZIF connector (1) the webcam/microphone module cable is connected to, and then
disconnect the webcam/microphone module cable (2) from the webcam/microphone module.
The display panel cable is available using spare part numbers N94786-001 (for use on
computer models equipped with a touchscreen display panel) and N94785-001 (for use on
50
Chapter 5 Removal and replacement procedures for authorized service provider parts