Managing a power-on password
To set, change, or delete the power-on password:
1. Open Setup Utility by turning on or restarting the computer. When the Press the ESC key for Startup
Menu message appears in the lower left corner of the screen, press the f10 key.
– or –
Open Setup Utility by turning on or restarting the computer. When the Press the ESC key for Startup
Menu message appears in the lower left corner of the screen, press the esc key. When the Startup
Menu appears, press the f10 key.
2. Use the arrow keys to select Security > Set Power-On Password, and then press the enter key.
●
To set a power-on password, type your password in the Enter New Password and Confirm
New Password fields, and then press the enter key.
●
To change a power-on password, type your current password in the Enter Current
Password field, type a new password in the Enter New Password and Confirm New
Password fields, and then press the enter key.
●
To delete a power-on password, type your current password in the Enter Current
Password field, and then press the enter key four times.
3. To save your changes and exit Setup Utility, use the arrow keys to select Exit > Exit Saving
Changes.
Changes go into effect when the computer restarts.
Entering a power-on password
At the Enter Password prompt, type your password, and then press the enter key. After three
unsuccessful attempts to enter the password, restart the computer and try again.
86 Chapter 11 Security
To Next Page
Loading...
Need help?
General