1
Switch Overview
Switch Hardware Features
The ProCurve Series 2810 Switches (Switch 2810-24G (J9021A) and Switch
2810-48G (J9022A)) are store-and-forward, multiport Gigabit switches
offering low latency for high-speed networking.
Switch Ports
A Switch 2810-24G has 20 and a Switch 2810-48G has 44 auto-sensing 10/100/
1000Base-T RJ-45 ports. RJ-45 ports are IEEE 802.3ab Auto MDI/MDI-X.
Both switches have four dual-personality ports—either auto-sensing 10/100/
1000Base-T RJ-45 or mini-GBIC. Dual-personality ports use either the 10/100/
1000Base-T RJ-45 connector, or a supported ProCurve mini-GBIC for fiber-
optic connections. By default, the RJ-45 connectors are enabled.
Series 2810 switches use the console port to connect to a PC or workstation
running a VT-100 terminal emulator, or a VT-100 terminal. A cable to connect
the switch to the console device is supplied.
Series 2810 switches do not have a power switch. They power on when
connected to an active AC power source. These switches automatically adjust
to any voltage between 100---240 volts and either 50 or 60 Hz. No voltage range
settings are required.
Fault
Power
Locator
Console
RPS
Fan
Spd
FDx
Act
Test
ProCurve Switch 2810-48G
Power, Fault,
and Locator
LEDs
Test, Fan and RPS
Status LEDs
Port Link LED Port Mode LED
Console
port
Reset and Clear
buttons
LED Mode select button
and indicator LEDs
10/100/1000Base-T
RJ-45 ports*
Dual-personality ports
(10/100/1000Base-T* or
mini-GBIC)
*
10/100/1000Base-T ports have the IEEE Auto MDI/MDI-X feature.
To Next Page
Loading...
Need help?
General