Access Control Lists (ACLs) for the Series 3400cl and Series 6400cl Switches
Configuring and Assigning an ACL
ACL “60” is listed in the
switch configuration.
ACL “60” is assigned to
filter inbound traffic on
port 20.
Show config lists any
ACLs and ACL
assignments configured
in the startup-config.
ACL “50” from the
preceding example.
Denies IP traffic from the
indicated IP address. Since, for
this example, ACL 60 is a new
list, this command also creates
the ACL.
Denies IP traffic from the
indicated IP address.
Permits IP traffic from all
sources. (Traffic from the IP
sources in the first two lines is
already filtered and dropped.)
The deny any with which the
switch implicitly concludes all
ACLs is preempted by this ACE
(but is still present in the ACL).
Figure 10-16. Example of Configuring a Standard ACL To Deny Inbound Traffic from Specific IP Addresses
10-47
To Next Page
Loading...
Need help?
General